Description

Functions to control the sample frequency of the oscilloscope.

The rate at which samples are taken by the oscilloscope is called the sample frequency, the number of samples per second. A higher sample frequency corresponds to a shorter interval between the samples. With a higher sample frequency, the original signal can be reconstructed much better from the measured samples.

The maximum supported sample frequency depends on the used instrument and its configuration. Use ScpGetSampleFrequencyMax to determine the maximum supported sample frequency of a oscilloscope.

The sample frequency can be affected by changing the channel enable, resolution and/or measure mode.

By default the sample frequency is set to the highest value available.

Functions
double	ScpGetSampleFrequencyMax (LibTiePieHandle_t hDevice)
	Get the maximum supported sample frequency of a specified oscilloscope. More...

double	ScpGetSampleFrequency (LibTiePieHandle_t hDevice)
	Get the currently selected sample frequency of a specified oscilloscope. More...

double	ScpSetSampleFrequency (LibTiePieHandle_t hDevice, double dSampleFrequency)
	Set the sample frequency of a specified oscilloscope. More...

Function Documentation

double ScpGetSampleFrequencyMax ( LibTiePieHandle_t hDevice )

Get the maximum supported sample frequency of a specified oscilloscope.

Parameters

[in] hDevice A device handle identifying the oscilloscope.

Returns: The maximum supported sample frequency in Hz, or 0 when unsuccessful.

Status values

INVALID_HANDLE	The handle is not a valid oscilloscope handle.
OBJECT_GONE	The object indicated by the handle is no longer available.
LIBRARY_NOT_INITIALIZED	The library is not initialized, see LibInit().
SUCCESS	The function executed successfully.

See also: ScpGetSampleFrequency; ScpSetSampleFrequency

Since: 0.4.0

double ScpGetSampleFrequency ( LibTiePieHandle_t hDevice )

Get the currently selected sample frequency of a specified oscilloscope.

Parameters

[in] hDevice A device handle identifying the oscilloscope.

Returns: The currently selected sample frequency in Hz, or 0 when unsuccessful.

Status values

INVALID_HANDLE	The handle is not a valid oscilloscope handle.
OBJECT_GONE	The object indicated by the handle is no longer available.
LIBRARY_NOT_INITIALIZED	The library is not initialized, see LibInit().
SUCCESS	The function executed successfully.

See also: ScpGetSampleFrequencyMax; ScpSetSampleFrequency

Since: 0.4.0

double ScpSetSampleFrequency	(	LibTiePieHandle_t	hDevice,
		double	dSampleFrequency
	)

Set the sample frequency of a specified oscilloscope.

Parameters

[in]	hDevice	A device handle identifying the oscilloscope.
[in]	dSampleFrequency	The required sample frequency in Hz.

Returns: The actually selected sample frequency in Hz, or 0 when unsuccessful.

Remarks: Changing the sample frequency may affect the record length, trigger time out, trigger delay, channel trigger enabled and/or channel trigger time(s) value(s).; Changing the sample frequency may change the resolution if auto resolution mode is AR_NATIVEONLY or AR_ALL.

Status values

VALUE_CLIPPED	The requested sample frequency is outside the valid range and clipped to the closest limit.
VALUE_MODIFIED	The requested sample frequency is within the valid range but not available. The closest valid value is set.
INVALID_VALUE	The requested value is invalid.
INVALID_HANDLE	The handle is not a valid oscilloscope handle.
OBJECT_GONE	The object indicated by the handle is no longer available.
LIBRARY_NOT_INITIALIZED	The library is not initialized, see LibInit().
SUCCESS	The function executed successfully.

See also: ScpGetSampleFrequencyMax; ScpGetSampleFrequency

Since: 0.4.0